Idle Learn Procedure
Whenever the battery cables, the engine control module (ECM), or the ECM fuse is disconnected or
replaced, the following idle learn procedure must be performed:
1.Turn the ignition ON for 5 seconds.
2.Turn the ignition OFF for 5 seconds.
3.Turn the ignition ON for 5 seconds.
4.Start the engine in park/neutral.
5.Allow the engine to run until the engine coolant is above 185° F (85°C ).
6.Turn the A/C ON for 10 seconds, if equipped.
7.Turn the A/C OFF for 10 seconds, if equipped.
8.If the vehicle is equipped with an automatic transaxle, apply the parking brake. While pressing the
brake pedal, place the transaxle in D (drive).
9.Turn the A/C ON for 10 seconds, if equipped.
10.Turn the A/C OFF for 10 seconds, if equipped.
11.Turn the ignition OFF. The idle learn procedure is complete.
怠速学习程序
每当电瓶电缆、发动机控制模块(ECM)、或ECM保险丝断开或更换,必须完成以下怠速学习程序:
1、把点火开关放到ON位5秒。
2、把点火开关放到OFF位5秒。
3、把点火开关放到ON位5秒。
4、起动发动机并置于停车位或空档(指变速箱)。
5、让发动机运转直到发动机冷确剂温度大于185° F (85°C )。
6、如安装有空调(A/C),把空调打开,让其运行10秒。
7、如安装有空调(A/C),把空调关闭10秒。
8、如果车辆安装有自动变速箱,将变速箱置于停留刹车位(P挡)。踩住刹车踏板,将变速箱置于D挡。
9、如安装有空调(A/C),把空调打开,让其运行10秒。
10、如安装有空调(A/C),把空调关闭10秒。
11、把点火开关置于OFF位。怠速学习程序完成。