独乐乐不如众乐乐，无意中发现国外友人研究出不用福特账号刷导航的办法，共享出来大家研究一下
以下是原文:
How to active MyfordTouch Navigation
Modify the APIM as-built data using Forscan (you will need to request an extended license for Forscan)
You will also need a ELM327 device that can do HSCAN/MSCAN.
1) Program APIM using Forscan & ELM327 device. Change the as built data bit with
(7d0-01-02. Byte 1 = 00 No Nav. Byte 1 = 04 with Nav)
Turn key off, turn on, sync black screen for a bit, then performing routine system maintenance.... for about 2 mins.
*Unknown if ACM as built data bit needs to be changed yet.
2) Program ACM as build with bit mentioned in this thread. Not sure needed/what it does but I did it anyway.
3) Download license (BT4T-14F500-BE) from URL attached in the excel document. You will need to replace “YAABBCCD” in the URL section and provide your vehicle’s ESN number otherwise it won’t work. This appears to be case sensitive so make sure it is all uppercase letters.
You can get the ESN number in the settings section on the myfordtouchunit. You do not need to change anything else in the URL.
*To do non-north america and non-latest software you will need all the proper field values for your vehicle from the as build and from the current software installed on the vehicle.
*Ford could change this URL and this would no longer work!
4) Create the USB device and edit the autoinstall.lst file to only install the BT4T-14F500-BE file.
5) Stick in A7 nav SD Card.
6) Enjoy the trip!
All credit goes to flsdiver for the URL/Excel doc/steps needed.
*****
[ 本帖最后由 den_18 于 2016-5-11 11:38 编辑 ]

这个翻译水平，呵呵呵

对，用327修改APIM的一个字节激活，然后好像再刷一次

按照原文的意思，还差一个激活文件，我找找个信息来源的网站，以后用327免费刷导航的日子快要来了

我在找出处，出处应该有那个文件的

呵呵呵 ，哪个证书我还在下载，一共是多少兆的啊？下载很慢阿

有的人就想拿来赚钱

地图ＳＤ卡爱卡群有人卖，好像是包邮

英文那个就是教程啊