发表于 2007-10-09 16:31 IP属地:未知
CRASH PAD MAIN REPLACEMENT
Note: You really should not be removing this much of your dash. I don't recomend you do it. You should only do this if you must. You are required to remove the wires going to the airbags. If not reconected correctly they will not deploy in an accident. (BE VERY CAREFUL!!!)
Step 1: Remove the following items.
Front seat assemble.
Cluster facia panel, cluster.
Lower crash pad panel.
Glove box.
Side cover.
Front pillar trim.
Center facia upper, lower cover.
Step 2: Disconnect the passenger’s air bag connector(A)
Step 3: Loosen the bolt`s and nuts then remove the main crash pad assembly(B).
When reinstaling note these!
-Make sure the crash pad fits on to the guide pins correctly.
-Before tihgtening the bolts, make sure the crash pad wire harnesses are not pinched.
-Make sure the connectors are plugged in properly, and the antenna lead is connected properly.