CRASH PAD MAIN REPLACEMENT
Note: You really should not be removing this much of your dash. I don't recomend you do it. You should only do this if you must. You are required to remove the wires going to the airbags. If not reconected correctly they will not deploy in an accident. (BE VERY CAREFUL!!!)
Step 1: Remove the following items.
Front seat assemble.
Cluster facia panel, cluster.
Lower crash pad panel.
Glove box.
Side cover.
Front pillar trim.
Center facia upper, lower cover.
Step 2: Disconnect the passenger’s air bag connector(A)
Step 3: Loosen the bolt`s and nuts then remove the main crash pad assembly(B).
When reinstaling note these!
-Make sure the crash pad fits on to the guide pins correctly.
-Before tihgtening the bolts, make sure the crash pad wire harnesses are not pinched.
-Make sure the connectors are plugged in properly, and the antenna lead is connected properly.

COWL CROSS BAR ASSEMBLE REMOVAL
Step 1: Remove the crash pad.
Step 2: Disconnect the connectors, after loosening the mounthing bolts and nuts remove the cowl crossbar(A).

here is what it looks like with all this done.

^^^^
Thats before removing the COWL CROSS BAR...
Once agian you should never have to remove all this stuff. The pic is of my '06 Accent which is currently in the shop they had to remove it all so they could weld on a new FT RT Rail.
[ 本帖最后由 愚人指路 于 07-10-09 16:34 编辑 ]

有些面板专业术语不好翻译啊，偶英文水平太烂，所以干脆把英文发上，其实不看英文都能明白的

志同道合啊，偶也为AUX才去找这个资料的，苦死我了。近期有空我就把它给改了
AUX改装我们可以相互交流交流啊，有懂电路的TX也可来相互交流啊。